It makes sense to be overly careful when using a search and replace command.
 It sometimes happens that what you get is not what you expect. You can undo any search and replacement command by entering 
u
, provided that the command was intended for the most recent edit you made. But you don't always catch undesired changes until it is too late to undo them. Another way to protect your edited file is to save the file with 
:w
 before performing a global replacement. Then at least you can quit the file without saving your edits and go back to where you were before the change was made. You can also read the previous version of the buffer back in with 
:e!
 (
30.4
)
.
It's wise to be cautious and know exactly what is going to be changed in your file. If you'd like to see what the search turns up   and confirm each replacement before it is made,  add the 
c
 option (for confirm) at the end of the substitute command:
:1,30s/his/the/gc
This command will display the entire line where the string  has been located, and the string will be marked by a series of carets (
^^^^
).
copyists at his school ^^^_
If you want to make the replacement, you must enter 
y
  (for yes) 'vs 12 and press  RETURN. If you don't want to make a change, simply press RETURN.
this can be used for invitations, signs, and menus. ^^^_
The combination of the 
vi
 commands, 
n
 (repeat last search) and dot (
.
) (repeat last command), is also an extraordinarily useful and quick way to page through a file and make repetitive changes that you may not want to make globally. So, for example, if your editor has  told you that  you're using 
which
 when you should be using 
that
, you can spot-check every occurrence of 
which
, changing only those that  are incorrect:  
/which
 | 
Search for which . | 
cwthat
 
[ESC]
 | 
Change to that . | 
n
 | 
Repeat search. | 
| . | Repeat change (if appropriate). | 
| . | |
| . | |
| . | 
-